Locations and Hours of Operation
Boca Raton Campus, Engineering West (EW), Room 164
Dania Beach, SeaTech Campus, Room 105
Both locations open 7:30 a.m. - 4 p.m., Monday through Friday.
Lab Access After Hours
Students that show responsibility and have been instructed in the lab equipment and safety procedures may be allowed lab access after normal hours at either location. If assistance is needed outside of normal hours email the lab staff to find out if an accommodation can be made.
Contacts
Services and Equipment
design review, system troubleshooting, component analysis, software development/debugging, electronics packaging, electronics circuit design, printed circuit board layout
lab safety, test equipment operation, soldering techniques, wiring and connector fabrication, CAD software
schematic capture, printed circuit board layout, embedded software development, circuit simulation
soldering irons, heat guns, reflow oven, oscilloscopes, multi-meters, signal/function generators, power supplies, hand tools, work benches
prototype parts, wire and connectors, fabrication materials, solder, heat-shrink, electronic hardware, breadboards
parts selection, vendor recommendations, university ordering procedures, pCard purchases and tracking
Lab Usage Rules
- Before working in the labs, students must review safety procedures with the lab staff.
- Before using any lab equipment, students must receive instruction on its use by the lab staff.
- No equipment or tools are to be removed from the lab without specific approval from the lab staff.
- Ask for assistance, don't guess.
- Keep areas clean and neat.